Pages

December 27, 2010

Defense Less? The story of Deepwater Horizons last moments

An investigation by the New York Times graphically depicts the last moments of the Deepwater Horizon oil rig.The article mentions the following:

"What emerges is a stark and singular fact: crew members died and suffered terrible injuries because every one of the Horizon’s defenses failed on April 20. Some were deployed but did not work. Some were activated too late, after they had almost certainly been damaged by fire or explosions. Some were never deployed at all.At critical moments that night, members of the crew hesitated and did not take the decisive steps needed. Communications fell apart, warning signs were missed and crew members in critical areas failed to coordinate a response.The result, the interviews and records show, was paralysis. For nine long minutes, as the drilling crew battled the blowout and gas alarms eventually sounded on the bridge, no warning was given to the rest of the crew. For many, the first hint of crisis came in the form of a blast wave.

The paralysis had two main sources, the examination by The Times shows. The first was a failure to train for the worst. The Horizon was like a Gulf Coast town that regularly rehearsed for Category 1 hurricanes but never contemplated the hundred-year storm. The crew members, though expert in responding to the usual range of well problems, were unprepared for a major blowout followed by explosions, fires and a total loss of power.They were also frozen by the sheer complexity of the Horizon’s defenses, and by the policies that explained when they were to be deployed. One emergency system alone was controlled by 30 buttons".

"The industry has long depicted blowout preventers as “the ultimate fail-safe.” But Transocean says the Horizon’s blowout preventer was simply incapable of preventing this blowout. Evidence is mounting, however, that the blowout preventer may have been crippled by poor maintenance. Investigators have found a host of problems — dead batteries, bad solenoid valves, leaking hydraulic lines — that were overlooked or ignored. Transocean had also never performed an expensive 90-day maintenance inspection that the manufacturer said should be done every three to five years. Industry standards and federal regulations said the same thing. BP and a Transocean safety consultant had pointed out that the Horizon’s blowout preventer, a decade old, was past due for the inspection.

Transocean decided that its regular maintenance program was adequate for the time being."

Read the full article in this link.

No comments:

Post a Comment